ASSEMBLY
1 > BOARD / MAST
Deep Tuttle Box full carbon + carbon HM
Inserts (Stainless steel A4) : 2 x ø12mm for M6 screw
2 > PLATINE D’APPUI
Torx screws (Stainless steel A4) : 4 x M4 x 20mm
+ shim (Inox A4) : 2 x ø 6mm
3 > MAST / FUSELAGE
Torx screws (Stainless steel A4) : 3 x M6 x 30mm
+ plugs (Inox A4) : 3 x ø12mm
4 > 2 safety lateral locks
Torx screws (Stainless steel A4) : 2 x M6 x 14mm
+ barrel screw (Stainless steel A4) : 2 x ø 8 x 24mm
5 > FRONT WING / FUSELAGE
Torx screws (Stainless steel A4) : 6 x M6 x 30mm
on exchangeable inserts (Stainless steel A4)
6 > REAR WING / FUSELAGE
Torx screws (Stainless steel A4) : 2 x M6 x 25mm
+ plugs interchangeables (Inox A4): 2 x ø12mm
+ Adjustment shims / Cales de règlage
Cale incorporée dans le fuselage
7 > BACK FIN / FUSELAGE
Torx screws (Stainless steel A4) : 1 x M4 x 25mm
+ brass plug : 1x ø 7mm
GOLIATH GOALS
R&D
TECHNO
FULL CARBON
CONSTRUCTION
ASSEMBLY
FOILS.WING
SELECTOR
MAINTENANCE
WARNING !
– When you first install your foil, coat all the screw (including the deep tuttle box ones)
with molybdenum disulphide grease (MoS2).
– Regular maintenance is also necessary. Disassembly, rinsing with clear water and lubrication should be conducted on a regular basis to avoid problems with the screws / inserts.
– When replacing stainless steel screws, observe the recommended screw lengths.
TORQUE
WARNING !
– To tighten the screws, use a Torx screwdriver and apply a torque of 7Nm
NEW-GENERATION FOILS
